Configuring VxMark

Configuring VxMark requires an Admin card.

Admin and Poll Worker cards, front side
Admin and Poll Worker cards, back side

First, turn on your VxMark (or VxMarkPrint). You should see the following screen:

VotingWorks has pre-programmed the Admin Card with your election definition. Simply insert your Admin Card into the card reader. You should see the following screen:

Tap the Load Election Definition, and within seconds, you should see the Admin screen:

Tap the Precinct drop-down menu and configure this VxMark for a specific precinct:

Your VxMark (or VxMarkPrint) is now configured! You should be in Testing Mode, where the VxMark will be fully featured, only the starting screen will indicate Testing Mode, and every ballot printed will be a test ballot that cannot be tabulated alongside live ballots.

Remove the Admin Card, and your VxMark (or VxMarkPrint) is ready for L&A Testing.