Central System Setup
Precinct System Setup
L&A Testing
Poll Worker Guides
Election Night Admin Guides
After Election Night
Reference
Packing Up VxMark
Use these instructions to pack up the VxMark Ballot Marking Device after the polls have closed.
Turn Off VxMark
The power button is located in the middle-right compartment next to the printer cable. To find it, run your finger along the side of the screen. Press the power button firmly for 1 second and then release. You should see the screen change as the machine starts to shut down.
Pack Up VxMark
Headphones
Unplug the headphones from the accessible controller. Place the headphones into the travel pouch.
Privacy Shield
The privacy shield will be stored back behind the top foam layer. Set the top foam aside. Lift the privacy shield up, fold it, and place it in the top lid. You can then put the top foam back in place, covering the privacy shield:
Privacy Shield Placed in Top Lid
Foam Covers Privacy Shield
Pack Cables
- 1.Unplug the power block from the outlet and place in the top-left compartment, with prongs facing up as shown below
- 2.Place the accessible controller in the bottom-left compartment, the the buttons facing outward
- 3.Unplug the printer cable from the printer and place inside case
Packed Power Block
Packed Accessibility Controller
Close VxMark
Make sure that:
- 1.Headphone Pouch is inside the case, on top of the screen
- 2.All cords are within case and not overflowing
Your VxMark should look something like this:
Close and latch the case.
Pack Up Printer
- Unplug printer power cord from the outlet and the printer
- Place the printer in its case
- Place power cord inside the case
- Close the case
​
Previous
Handling Results and Packing Up VxScan
Next - Election Night Admin Guides
Election Night Checklist
Last modified 1mo ago
Export as PDF
Copy link