VxMark Hardware Setup

VxMark Setup

Part of the Precinct System, VxMark is an accessible ballot marking device that gives voters the ability to mark their choices and print their ballot from a touchscreen.

VxMark can be set up through the following steps:

Set up the stand:

raise leg to snap in place
all legs in place
support bar
snap support bar to back legs
support bar installed
add power block holder
insert power block into the holder
power block and holder installed

Set up the ballot marking device:

ballot marking device
place ballot marking device on the stand
power cord connector
power cord connector plugged in
power plug
power cord plugged in
push the printer cover button
open the printer cover
ballot bin
slide ballot bin into place
document and seal as required
privacy shield pegs
privacy shield holes
privacy shield installed
plug the headphones in
push the power button to turn on

The VxMark is set up.

Cleaning VxMark

The scanner should be cleaned for every election with scanner cleaning solution (see Supply List) and a lint-free or microfiber cloth.

Last updated