Packing Up VxScan

Pack up VxScan through the following steps:

1. Pack up the scanner:

• Insert the poll worker card and select Power Down to turn VxScan off. VxScan has shutdown properly once the screen is off and presents no content.

• Once the screen is off, remove the power cord from VxScan

• Disconnect the power cord from the Goldenmate UPS, then pack up the UPS

• Wrap the power cord in its storage space

• Push the purple release button to the left to release the case from the ballot box

• Close the poll worker door

• Close the case lid and latch

• Seal and document the case seal(s) as required

1. Pack up the ballot box:

• Unseal and/or unlock the ballot box

• Remove all ballots from the ballot box and seal into a secure container, recording the seal number as required

• Press the latch on the lid to release the lid and lift the lid over to the side

• Fully collapse the ballot by gently using your foot to lift the bottom purple hooks

• Remove the straps from the underside of the lid and tighten them around the side