VxAdmin Hardware Setup

Hardware Overview

VxAdmin is a commercial off-the-shelf (COTS) laptop pre-installed with VotingWorks software and an optional printer. All USB drives, cords, adapters, and programmable smart cards needed to operate the system are included and stored in an orange case. An APC uninterruptible power supply (UPS) provides backup power to the VxAdmin printer.

VxAdmin Setup

1. Unbox and Set Up Printer:

   • remove the printer and power cord from the case

   • plug the power cord into the back of the printer

   • plug the power cord into the APC UPS which is connected to AC power

   • press the power button to turn the printer on

   • load paper into the lower paper tray

2. Set Up VxAdmin laptop:

• remove and document seals as necessary,

• open the case by lifting the latches on the front

• remove the laptop

• pull the power cord (A) out and plug into the laptop and an outlet

• pull the USB hub (B) out and plug into the laptop

To pack up the VxAdmin, simply place all of the components back into the case as displayed above. Secure the case as required by sealing the eyelets highlighted below. Disconnect the printer power cord from the APC UPS. Pack up the printer and its power cord and the APC UPS.