When L&A is complete, select Tally from the side menu, then select Remove CVRs to clear VxAdmin of CVRs to prepare for election day. Confirm by selecting Remove CVRs in the popup confirmation screen.
If you used test ballot mode to conduct your L&A be sure to put VxScan into official ballot mode. Insert the election manager card into VxScan and select Official Ballot Mode.
If you used Official Ballot Mode to conduct your L&A, simply toggle to Test Ballot Mode and back to Official Ballot Mode to reset VxScan for election day.
Remove the election manager card and confirm that the VxScan is in official ballot mode by checking that there is no orange Test Ballot Mode banner, Polls Closed is displayed, and the Sheets Scanned count is 0.
A USB drive is required to use VxScan on election day. After testing, you may re-insert the USB drive used during testing or a new USB drive into the USB port and seal the machine until a poll worker accesses it on election day. If official ballot mode was used, we strongly recommend using a new USB drive for election day.
If you used test ballot mode to conduct your L&A be sure sure to put VxCentralScan into official ballot mode. Insert an election manager card, select Settings from the side menu and then tap Official Ballot Mode.
If you used Official Ballot Mode to conduct your L&A, simply toggle to Test Ballot Mode and back to Official Ballot Mode to reset VxCentralScan for election day.
If you used test ballot mode to conduct your L&A be sure to put VxMark into official ballot mode. To change modes, insert your election manager card and select Official Ballot Mode.
If you used Official Ballot Mode to conduct your L&A, simply toggle to Test Ballot Mode and back to Official Ballot Mode to reset VxMark for election day.
